The automatic indentation die-cutting machine occasionally gets stuck, but it is unclear where the stuck paper is coming from, resulting in a headache. Here, the editor shares some knowledge about indentation. Utilize fast die-cutting, use high-speed die-cutting for cutting, then soften with extracted resin, and press with an optical engraving knife or gold wool machine. Firstly, there is a layer of resin layer on the surface of the resin that has a certain degree of ductility. In normal indentation die cutting, we need to remove some resin, but automatic indentation die cutting is different. This is a choice of die cutting method. Choosing some artificial silicone or silicone with resistance, such as Raybond, MoNeng, etc., can achieve better results. If you want to learn more, please consult with the teacher or manufacturer. The above is from Lida Steel Seal Automatic Indentation Grinding Tool
Firstly, you need to identify the area where the paper jam appears, and then prescribe the appropriate treatment. If it is on a smooth surface, extract resin and use rubber or other tools to cut and polish it; If it is for the high gloss surface, the resin and mold need to be polished together. On the contrary, the indentation machine produces the high gloss surface. For the flat surface, only the resin is extracted, and for the high gloss surface, it needs to be polished together. Secondly, there is an operational issue. If it is an indentation machine with an automatic indentation optical coding machine, it is basically difficult to distinguish, because when the mold and optical cutting are seen together, it is inevitable to have some confusion; If there are differences in the workflow between the mold and optical processing, one should pay attention to the differences in the workflow. One is to first make gold wool strips, then process them, and if removed, polish them. (Microcontrollers and general indentation machines are processed in the same way, only two chip machines have a difference).
It is normal for the automatic indentation die-cutting machine to occasionally jam paper, as it does not have a horizontal cutting function. Nowadays, researchers have switched to manual indentation and cutting, as long as you press it, it becomes stable.
I don't know. What I learned from an automatic indentation master is to always turn on the machine and remove the paper.
Not only this problem, but I have produced more perfect knife marks. When testing the other two machines, either the knives were not smooth enough or they did not match the actual situation. Why is this
It should be a problem with the turbo pump. It seems that the turbo is not rotating. From an angle, the edge of the indentation is curved, so it will be fine when it rotates. I have been pressing it out like this without any flaws.
There are two possibilities, one is due to structural reasons, and the other is quality issues with the machine itself. The hydraulic pump is not very good. The general range of indentation pressure is between 65-85m. Hardness requirements for indentation edges above 130m are high, and common indentation edge hardness levels include 60, 40, 30, and 10. If a knife mark is produced, first use a 50pa air compressor to achieve a hardness level of 10 (the softness and hardness are relative to the indentation). Under a pressure of 50pa, the indentation should reach a hardness level of 30 (the hardness requirement is that the edge maturity of the indentation should reach a hardness level of 5). Another thing is to use a dedicated indentation machine. Common ones are right angle reverse cutting machines. There are also equipment such as indentation printers, indentation puffing machines, indentation folding machines, indentation cutting machines, and indentation magnetic plastic machines. The delivery of the indentation machine is guaranteed. There is no issue with tail goods. Good quality is crucial to ensure the normal operation of parts and rotors. The quality of the indentation machine produced by a legitimate manufacturer is reliable.